Snow Joe TRJ609E Operator's Manual download pdf (Page 9)

Winding the line

NOTE: A dual-line factory wound spool (Model TRJ609ERS) is

available for easy spool replacement on the TRJ609E electric

grass trimmer. Visit www.snowjoe.com to purchase. Should

you wish to wind the line yourself, the instructions are provided

below. Self-winding, however, is NOT recommended because

if the line is not wound properly it can cause the trimmer’s

bump feed system to malfunction. For this reason, users are

strongly urged to purchase the pre-wound spool.

1. The spool can hold 16.4 ft (5 m) of line. Remove the white

cover. Holding the loose ends of the line together with

one hand, nd the center of the line with the other hand

and hook this center loop into the groove on the spool as

shown in Fig. 14.

2. Wind the line following the directional arrows on the

spool housing and hook the two ends into the side

grooves (Fig. 15).

3. Firmly place the white cover on the spool and pull the

two ends approximately 3.5 inch (9 cm) out of the spool

(Fig. 16)

4. Along the groove, slide the line into the hole in the spool

cover (Fig. 17).

5. Prepare to assemble the spool into the trimmer.

Fig. 13

Spool

Fig. 14

Fig. 15

Fig. 16

Fig. 17

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Snow Joe TRJ609E Operator's Manual Page 9