Snow Joe TRJ609E Operator's Manual Page 2

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 1
2
Do not switch the grass trimmer on in enclosed or poorly
ventilated spaces or in the presence of ammable and/or
explosive substances such as liquids, gases, and powders.
The user of the grass trimmer is responsible for any damage
sustained by third parties that has been caused by the
grass trimmer within the working area.
Only cut during broad daylight or with adequate articial
light.
Do not cross roads or gravel paths while the trimmer
is still running.
When the trimmer is not in use, store it in a dry place and
out of the reach of children.
The trimmer must be operated in a vertical position,
perpendicular to the ground.
Check regularly that all screws are properly secured.
Electrical Safety Rules
The voltage must correspond to the one marked on the
technical data plate (120 V~60 Hz). Do not use other
sources of power.
The power line should have a circuit breaker no lower than
10 A. Consult an electrician if this is not the case.
Do not abuse the cord – Never carry the tool by the cord
or yank the cord to disconnect it from the receptacle. Keep
cord away from heat, oil, and sharp edges.
Never pass the grass trimmer over the extension cord when
the grass trimmer is in use as this could cut the cord. Make
sure you know where the cord is at all times.
Use the special cord holder to connect the extension cord.
Never use the trimmer when it is raining or when
excessively moist and humid conditions present. Do not
cut damp grass or leave the trimmer outside overnight.
The power supply cable should be checked regularly to
make sure it is perfectly intact without any signs of wear or
damage. If the cable is not in good condition, do not use
the trimmer.
Only use an extension cable that is rated for outdoor use.
Keep the extension cord away from the cutting area, sharp
edges, heat, fuels and damp, oily surfaces.
mWARNING! To reduce the risk of electric shock, use only
with an extension cord intended for outdoor use, such as
an extension cord of cord type SW-A, SOW-A, STW-A,
STOW-A, SJW-A, SJOW-A, SJTW-A, or SJTOW-A.
Damage to unit – If the trimmer strikes a foreign object
or becomes entangled with it, stop the tool immediately.
Unplug it, check for damage and have any damage repaired
before further operation is attempted. Do not operate the
trimmer with a broken hub or spool.
Damage to cord Keep power cord away from the rotating
line. If you damage the cord, unplug it from the power
supply before moving the tool or examining the damage.
A damaged cord must be replaced before further use.
Disconnect the tool Turn the trimmer off and disconnect
the plug when the trimmer is not in use, when replacing the
line, or prior to performing any maintenance task.
Avoid dangerous environmental conditions Do not use
electric tools in damp or wet locations. Do not use the tool
in the rain. Follow all instructions in this manual for proper
operation of your tool.
Do not operate portable electric tools in a gaseous or
explosive atmosphere – Motors in these tools normally
spark, and the sparks might ignite fumes.
Store idle tools indoors When not in use, tools should
be stored indoors in a dry, locked-up place out of the reach
of children.
Ground fault circuit interrupter (GFCI) protection should
be provided on the circuits or outlets to be used for this
gardening appliance. Receptacles are available having built
in GFCI protection and may be used for this measure of
protection.
Secure extension cord – Use the cord retainer shown in
Figure 4.
STAY ALERT – Watch what you are doing. Use common
sense. Do not operate the trimmer when you are tired or
under the inuence of alcohol or drugs.
Maintain appliances with care Follow instructions for
lubricating and changing accessories. Inspect extension
cords periodically and replace if damaged. Keep handles
dry, clean and free from oil and grease.
Check for damaged parts Before further use of the
appliance, a guard or other part that is damaged should be
carefully checked to determine that it will operate properly
and perform its intended function.
Check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any other condition
that may affect the trimmer’s operation. A guard or other
part that is damaged should be properly repaired or
replaced by an authorized service center unless indicated
otherwise in this manual.
Page view 1
1 2 3 4 5 6 7 ... 11 12

Comments to this Manuals

No comments