Snow Joe ION8024-XR Owner's Manual download pdf (Page 14)

Pre-Start

1. Charge batteries – See Charger Operation section on

page 10.

2. Check function of triggers – If triggers cannot engage or

disengage properly, adjust or repair before operation.

3. Check Skid Shoes – Check and adjust skid shoes (See

Assembly section on page 9; g. 7).

Emergency Stop

Immediately release both triggers to stop unit in an emergency.

Disengage safety switch, remove key and wait for all rotating

parts to stop before leaving operator’s position.

Operation

mWARNING! Failure to follow instructions could result

in personal injury and/or damage to snow blower. DO NOT

attempt to start your snow blower at this time. Read entire

operator manual rst.

See page 11 for all controls and features.

mWARNING! Keep the area to be cleared free of stones,

toys or other foreign objects that the rotor blades might pick

up and throw. Such items could be covered by snow and are

easy to overlook, so be sure to conduct a thorough inspection

of the area before beginning work.

Starting the Machine

IMPORTANT! Disengage safety switch and release both

triggers before turning power switch to ON position.

1. Open the battery compartment cover and slide two

battery packs down until they both click and lock into

position (Fig. 18). Close the cover.

2. Rotate the safety switch clockwise and pull up the safety

switch. Drive motor will not yet run (Fig. 19).

3. Insert key and turn power switch to the ON position. The

side LED windows and control panel buttons will glow

(Fig. 19).

To Engage Auger

NOTE: Auger trigger should be engaged before drive trigger

when throwing snow.

1. To engage the auger, press the safety button then squeeze

the auger trigger against the right-handle (Fig. 20).

2. Release auger trigger to stop the auger.

IMPORTANT! DO NOT overload unit capacity by attempting to

clear snow at too fast a rate. Use slow speed to clear deep or

hard packed snow.

Fig. 18

Battery

packs

Battery

compartment

cover

Fig. 19

Safety key/Power switch

Safety switch

Fig. 20

Safety button

Auger trigger

(Right-handle)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Comments to this Manuals

No comments

Snow Joe ION8024-XR Owner's Manual Page 14

Comments to this Manuals