Snow Joe Pressure Joe SPX1000 Operator's Manual download pdf (Page 9)

Service and Support

If your Electric Pressure Washer requires service or

maintenance, please call 1-866-766-9563 for assistance.

Model and Serial Numbers

When contacting the company or reordering parts, you will

need to provide the model and serial numbers of your product.

These are found on the decal afxed to the housing or guard

of your Electric Pressure Washer. Copy these numbers into the

space provided below.

Record the following numbers from the housing or handle of your

new product:

S P X 1 0 0 0

Model #:

Serial #:

Troubleshooting

• Disconnect from the electrical power supply before carrying out user maintenance or checking its correct functioning.

• To avoid unnecessary disappointments, you should check the following before contacting the service organization:

Problems Possible Cause Possible Solution

Machine refuses

to start

• Power failure/machine not plugged

into a working receptacle.

• Defective socket.

• Fuse has blown.

• Defective extension cord.

• Check to make sure machine is plugged into

a working outlet.

• Replace fuse. Switch off other machines.

• Try without the extension cord.

• Check the hoses and connections are airtight.

• Clean and replace or refer to local distributor.

• Check that the mains voltage corresponds to

specication on the model tag.

• Leave the washer for 5 minutes to cool down.

Clean the nozzle.

• Change to an installation higher than the amp

consumption of the machine. You may try without the

extension cord.

• Allow machine to run with open trigger until regular

working pressure resumes.

• Check that the water supply corresponds to

specications required.

• WARNING! Avoid using long, thin hoses (min. 1/2 in.).

• Clean the nozzle.

• Clean the lter.

• Straighten out hose.

• Please call 1-866-766-9563 for assistance.

• Wait for pump/hoses or accessories to thaw.

• Connect inlet water.

• Clean the lter.

• Clean the nozzle.

• Pump sucking air.

• Valves dirty, worn out or stuck.

• Pump seals worn out.

• Fuse has blown.

• Incorrect mains voltage.

• Thermal sensor activated.

• Nozzle partially blocked.

• Fuse too small.

• Air in inlet hose.

• Inadequate supply of mains water.

• Nozzle partially blocked.

• Water lter blocked.

• Hose kinked.

• Pump/spray gun is leaking.

• Pump/hoses or accessories frozen.

• No water supply.

• Water lter blocked.

• Nozzle blocked.

Fluctuating pressure

Machine stops

Fuse blows

Machine pulsating

Machine often starts

and stops by itself

Machine starts, but

no water comes out

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Snow Joe Pressure Joe SPX1000 Operator's Manual Page 9

Comments to this Manuals

Related products and manuals for High-pressure cleaners Snow Joe Pressure Joe SPX1000