Snow Joe Shredder Joe SDJ616 Operator's Manual download pdf (Page 9)

Replacing the Cutting Line

This electric leaf mulcher/shredder features a bladeless

mulching system that utilizes 0.1 in. x 12.6 in. (0.25 cm x 32

cm) heavy-duty trimmer line. Twenty replacement cutting lines

are included in the box. Visit www.snowjoe.com

to purchase additional cutting line (Model SDJ616L).

1. Replace the cutting line when a noticeable decrease in

shredding efciency is observed. To remove the worn

cutting lines, cut the old lines and pull the remaining line

out of the spinner head.

2. When installing new cutting lines, feed each end of the

new line through the two holes in the post on top of the

spinner head (Fig. 13).

3. Check that the two ends of the line are even in length on

both sides (Fig. 14).

4. Thread the lines through each corresponding ferrule

(Fig. 15).

5. Ensure that both ends of the line are straight and are

even in length (Fig. 16).

NOTE: There is a built-in line cutter that will cut and trim

the lines slightly longer than desired.

6. Refer to the above steps to replace another cutting line

(Fig. 17).

Fig. 13

Fig. 14

Fig. 15

Fig. 16

Fig. 17

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Snow Joe Shredder Joe SDJ616 Operator's Manual Page 9